3
2
PREPARATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
The code is programmed by using the HM-195.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
After programming the MMSI code, “Push [ENT] to Regis- q
ter Your ATIS” is displayed.
Push [ENT] to start the ATIS code programming. w
฀ •฀฀Push฀[CLEAR]฀twice฀to฀cancel฀the฀programming,฀and฀go฀to฀the฀
normal operating mode. In this case, the ATIS function is dis-
abled. To program the ATIS code, turn OFF the power, then turn
it ON again.
Enter your ATIS code in the following manner: e
฀ •฀Select฀a฀desired฀number฀using฀Dial,฀or฀[]/[]/[]/[].
฀ •฀Push฀[ENT]฀or฀Dial฀to฀set฀it.
฀ •฀฀To฀move฀the฀ cursor,฀select฀either฀arrow,฀“” or “,” then push
[ENT] or Dial.
Repeat step r e to enter all 10 digits.
After entering the 10 digit code, “FINISH” is automatically t
selected, and then push [ENT] or Dial to set it.
The “ATIS CONFIRMATION” screen is displayed. y
Enter your ATIS code again for confirmation. u
฀ •฀Enter฀in฀the฀same฀manner฀as฀steps฀e through t.
When your ATIS code programming is successfully com- i
pleted, the screen shown below is briefly displayed.
฀ •฀After฀that,฀the฀normal฀operating฀screen฀is฀displayed.
The programmed ATIS code can be checked in the MENU
screen.
ATIS code programming (For Dutch version transceivers)
2006-2020 Rsmanuals.com