Performance Verification
WFM700 Series Waveform Monitors Service Manual 2-7
5. Enable or reconnect the HD video generator signal to INPUT A.
6. CHECK that the red IInput UnlockedImessage is gone.
7. Set the HD video generator for 2 groups of embedded audio, starting with
group 1.
8. Press the STATUS button.
9. Touch the Display soft key.
10. Touch the Session soft key and then touch the Done soft key.
11. Option DG only: Touch the Video Session soft key if necessary to select
Video Session.
12. CHECK that the embedded audio status reads as follows:
Embedded Audio: PPPP PPPP ---- ----
This procedure checks the input detection and audio disembedding data paths for
standard definition video.
1. Press the WFM button.
2. Press the INPUT button and touch the Input B soft key.
3. Disable or disconnect the SD video generator signal to INPUT B.
4. CHECK that the red IInput UnlockedImessage is displayed.
5. Enable or reconnect the SD video generator signal to INPUT B.
6. CHECK that the red IInput UnlockedImessage is gone.
7. Set the SD video generator for 2 groups of embedded audio, starting with
group 1.
8. Press the STATUS button.
9. Touch the Display soft key.
10. Touch the Session soft key and then touch the Done soft key.
11. Option DG only: Touch the Video Session soft key if necessary to select
Video Session.
12. CHECK that the embedded audio status reads as follows:
Embedded Audio: PPPP PPPP ---- ----
SD Input and Embedded
Audio Detection (WFM7A,
WFM7M only)
Terms of Use | Privacy Policy | DMCA Policy
2006-2023 Ready to Serve Manuals