Troubleshooting
WFM700 Series Waveform Monitors Service Manual 4-29
Table 4- 4: Failure symptoms and possible causes (cont.)
Symptom Possible cause(s)
Out of specification or malfunction of
the following:
SD PIX MON
SERIAL OUT
JITTER OUT
Eye, Jitter
Faulty Input Module.
One of the following error messages
are displayed:
INPUT UNLOCKED
#A: UNKNOWN
#B: UNKNOWN
HVerify the input signal is a known good signal.
HVerify the proper Input and slot are selected.
HFaulty Input Module.
The following video STATUS items
are indicated incorrectly:
Signal
Format
Embedded Audio
Embedded CRC
HFaulty Input Module.
With two video modules installed,
only one works
Swap the modules and recheck. If the fault follows the
suspected input module, the module is faulty. If the fault
remains in place (same slot), check the main board for
bent pins or the main board is faulty.
A second video module installed in slot 3 can only be
used if a functioning video module is in slot 2. Slot 2
must always contain a video module.
Audio performance verification
indicates the following failures:
Ext AES input
AES output amplitude, rise/fall
time, return loss
If the Performance Verification procedure for the Audio
option indicates a malfunction or is out of the
specification range, replace the Audio Module.
Audio performance verification
indicates the following failures:
AES output bit errors, excessive
jitter
Embedded source selection
Embedded audio presence
readout
If the Performance Verification procedure for the Audio
option indicates a malfunction or is out of the
specification range, replace the faulty Video module.
Terms of Use | Privacy Policy | DMCA Policy
2006-2023 Ready to Serve Manuals