Removal and Installation Procedures
WFM700 Series Waveform Monitors Service Manual 4--15
Slot 1Slot 2Slot 3Slot 4Slot 5Slot 6Power supply
Audio
module
Video
modules
Figure 4--6: WFM700 rear panel showing slot numbers
3. Prepare to insert the plug-in module by lining it up with the plastic guide
toward the front of the instrument and by placing the white ejector lever in
the down position, level with the module. See Figure 4--7.
4. Slide the module straight down, into the plastic guide, and line up the
connectors on the module with the pins on the Main board below.
5. Applying firm pressure to both ends of the module, press it all the way down
and into place.
6. Install and tighten the screw (T-15) that attaches the bottom of the module
rear panel to the instrument chassis.
7. A grounding clip is required when two video modules are installed. See
Figure 4--8 for the correct installation of the grounding clip.
