HARDWARE INSTALLATION
4
1) MOUNT OUTSIDE TRIM (WHEN REQUIRED) PER DIRECTIONS IN TRIM BOX, OR INSTALL OUTSIDE SEX BOLTS.
2) MOUNT DEVICE - THROUGHBOLT DEVICE TO TRIM OR SEXBOLTS.
3) LOCATE, MARK AND DRILL END CAP MOUNTING HOLE
:
A) LEVEL DEVICE.
B) MARK CENTER OF 5/16" DIA. HOLE AT END OF CHANNEL.
C) DRILL 9/32" DIA. HOLE THRU DOOR.
D) DRILL 3/8" DIA. HOLE ON TRIM SIDE OF DOOR USING 9/32" DIA. HOLE AS GUIDE.
B) FOR RODS THAT ARE TOO SHORT, FOLLOW PROCEDURE BELOW.
1) ATTACH EXTENSION RODS TO THREADED SECTION OF TOP ROD.
2) FOLLOW INSTRUCTIONS TO MARK, CUT & DRILL TOP ROD (SEE STEP 1 OF PART A OF PREVIOUS
PAGE).
TOP ROD EXTENSION ROD
4)
INSTALL CHANNEL COVER.
LHR SHOWN
5) INSTALL END CAP MOUNTING BRACKET USING SEX BOLT AND SCREW
6) TIGHTEN ALL DEVICE MOUNTING SCREWS.
7) INSTALL TOP & BOTTOM LATCHES.
8) THREAD RODS ONTO DEVICE CENTERSLIDE. INSERT ROD CONNECTORS FROM TOP LATCH INTO OPPOSITE END OF
TOP ROD AND INSERT (BUT DO NOT BEND) COTTER KEY THROUGH ROD AND ROD CONNECTOR. INSERT BOLT
ASSEMBLY INTO OPPOSITE END OF BOTTOM ROD AND INSERT (BUT DO NOT BEND) COTTER KEY THROUGH ROD AND
BOLT ASSEMBLY.
#10x1-1/4" FPHSMS #10-24x3/4" FPHMS
SEX BOLT
END CAP
MOUNTING
BRACKET
MOUNTING SCREW
(1/4”-20x3/4” TPHMS)
