D-108 Owner’s Manual (MIDI Synchronization)
77
BUSS OUT (GROUP OUT) 1~8 TAPE IN 1~8
Mixing console
D-108
8TRACK DIGITAL RECORDER
OPTICAL
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE
REHEARSAL
TAKE
TIME BASE SEL
RECALLSTOREHOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDOUNDOERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUTINAUTO PLAY
AUTO PUNCH
START OUTIN END
TC INLOCKED HD ACCESS
RECORD TRACK
1/9 2/10 3/11 4/12 5/13 6/14 7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
POWER
ANALOG OUT 1~8
ANALOG IN 1~8
STEREO OUT L/R
MIDI OUT
MIDI IN
MIDI OUT
MIDI IN
MIDI IN
MIDI OUT
* If correct sync cannot be obtained, re-check the connections/cables and setting of both equipment.
<Note>
In the D-108, the "ABS 0" position is set at "002BAR/1BEAT /00CLK."
This setting is made in consideration of the time required (it will not sync immediately) for the MIDI sequencer, etc. to enter into sync.
As a result, if the D-108 is played back from ABS 0 (LOCATE ABS 0), sync will be completed by the time it reaches the first bar, and
will thus synchronize from head of the tune.
Execution of recording
Various ways of recording can be conducted while synchronizing the D-108 and the MIDI sequencer with the MIDI
clock.
MTC sync/MIDI machine control system
The following will explain synchronization by the MTC (MIDI time code) output and the computer controlling system
using MMC (MIDI machine control). In this system, the D-108 will be the master and the computer (with sequence
software) will be the slave. The D-108 will attach any desired offset (time difference) against ABS time (absolute time)
and output it as MTC in any desired frame rate.
It can also carry out the proper operation upon receiving an MMC and Fostex System Exclusive Message from outside.
In this case, because the D-108 can setup a DEVICE ID number by the SETUP mode "MIDI Device ID Setting" menu, a
multiple number of D-108's can be separately controlled by changing the DEVICE ID numbers in the transmitted
message from the computer. In regards to the corresponding content for MMC, refer to the "MMC list" on page "126"
and on the Fostex System Exclusive Message, the "Fostex Exclusive List" on page "127."
* Set D-108 in the initial state.
* Confirm the program and sampling frequency.
Master Recorder
Computer system
with
MMC/MTC soft ware
MIDI sound sources
MMC or Fostex System
Exclusive Message
MTC
MIDI
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com