43
D-108 Owner’s Manual (Punch In/Out Recording)
Manual Punch In/Out
This section explains how to perform Manual Punch In/Out using a foot switch (optional Model 8051).
You do not need to specify the Punch In/Out points. Instead, you press the foot switch at the Punch In/Out point.
Manual Punch In/Out also offers rehearsal and actual takes. You can repeat rehearsal until you are ready.
As an example, replace a part of the recorded guitar solo on track 3.
Initialize the D-108.
Select a desired Program for Punch In/Out.
Check a sampling frequency of the D-108.
Preparation
Check to see that the guitar is connected to the input jack of the mixer, as required for [AUTO PUNCH IN/OUT]
mentioned earlier.
Connect an optional foot switch (Model 8051) to the PUNCH IN/OUT jack on the rear panel.
Rehearsing Manual Punch In/Out recording
In Rehearsal mode, the READY track enters input monitoring mode between the Punch In and Out points (the
points at which you press the foot switch), and the sound is not recorded. You can practice the Punch In/Out
operation repeatedly before you proceed to actual recording.
1. Press the foot switch while holding down the STOP
button.
[Rehearsal On] will appear on the display dor about 1
second, then rehearsal mode will appear and the
REHEARSAL LED (green) of the AUTO PUNCH key flashes.
2. Press the RECORD TRACK select key [3] to set
track 3 to READY.
3. Press the PLAY button to play back from a point
slightly before the Punch In point.
PUNCH REHEARSAL
TAKE
AUTO
4. Play the guitar accompanying the playback of tracks
1 to 8.
The recording level and monitor volume is adjusted on
the mixer in the same manner as done for [AUTO PUNCH
IN/OUT] descrived earlier.
5. Press the foot switch once at the desired Punch In
point, then press the foot switch again at the desired
Punch Out point.
The rehearsal mode will operate as shown in the figure.
Between the Punch In and Out points the current
performance of the guitar will be played as the guitar
monitor sound. The previous recording is heard in any
other case. The RECORD LED lights up when Punching In
and turn off when Punching Out. (the REHEARSAL LED
remains flashing)
D-108
8TRACK DIGITAL RECORDER
OPTICAL
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE
REHEARSAL
TAKE
TIME BASE SEL
RECALLSTOREHOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDOUNDOERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUTINAUTO PLAY
AUTO PUNCH
START OUTIN END
TC INLOCKED HD ACCESS
RECORD TRACK
1/9 2/10 3/11 4/12 5/13 6/14 7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
POWER
Foot Switch Model 8051
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com