TASCAM SS-R250N 77
10 – Mark and Locate Functions
Locating to a specific time
You can locate to a specific time using a USB keyboard when
stopped, playing back or in playback standby.
Locating is not possible if the playback mode is PROGRAM or
RANDOM or the playback area is PLAYLIST or FOLDER.
When the Home Screen is open, press the * (asterisk) key to clear
the track number and time display and enable numerical input.
Use the keypad to enter numbers in the following order.
0Track number: 3 digits
0Time elapsed from track beginning in hours, minutes, sec-
onds and 10msec increments (2 digits each)
For example, enter the following numbers in order to specify the
location 1 minute and 30 seconds from the beginning of track 2.
0 w 0 w 2 w 0 w 0 w 0 w 1 w 3 w 0 w 0 w 0
After inputting the 11th digit, the unit will automatically locate
to the specified time.
The status of the unit after locating will be the same as it was
before (stopped, in playback standby or playing).
For this reason, playback will resume at the new time after locat-
ing during playback.
Using the Backspace or / (backslash) key on the USB keyboard
will delete the last input number.
Locating before completely specifying the time
Before inputting all the numbers to specify a time, you can lo-
cate to the time specified immediately by pressing the Enter key
on the USB keyboard, the MULTI JOG dial or the PLAY or PAUSE
[CALL] button on the unit.
For example, entering the following incomplete time.
0 w 0 w 2 w 0 w 0 w 1 w 2
Press the PLAY button to locate to 12 minutes from the begin-
ning of track 2.
What happens after locating depends on which control was
If the MULTI JOG dial was pressed:
Playback or playback standby is resumed according to the
state before locating.
If the PLAY button was pressed:
If the PAUSE [CALL] button was pressed:
The unit enters playback standby.