54 TASCAM SS-R250N
7 – Recording
Setting mic/line input sensitivity
Before starting recording, input gains should be adjusted to
prevent recorded sounds or signals from being distorted due to
excessive input levels and to prevent them from being so low
that they are below the noise floor.
NOTE
This item will not appear when the input source is set to any-
thing other than ANALOG BALANCED.(see “Selecting the input
source” on page 52)
1. Select BAL.INPUT GAIN on the REC 1 page to open the
BALANCED INPUT GAIN screen.(see “Menu operation proce-
dures” on page 22)
2. Set the mic input sensitivity.
Option Meaning
LINE (default)
Use when connecting the line output jacks
of external devices to this unit’s MIC/LINE
IN (BALANCED) L/R jacks.
MIC-LOW Use when mics are connected to the MIC/
LINE IN (BALANCED) L/R jacks.
MIC-HIGH
NOTE
When REC SET LINK is set to OFF on the REC 1 page, the lev-
els of the left and right channel inputs are adjusted separate-
ly.(see “Setting left/right channel inputs separately” on page
53)
3. Confirm the setting and return to the Menu Screen.
Adjusting input signal levels
Use the following procedures to adjust input signal levels.
1. Select INPUT LEVEL on the REC 1 page to open the INPUT
LEVEL screen.(see “Menu operation procedures” on page
22)
INPUT LEVEL screen when adjusting line level
2. Adjust the input signal levels.
LINE LEVEL
(when BALANCE INPUT GAIN screen set to
LINE)
Options: -inf, -54dB, -48dB, -42dB, -36dB, -30dB, -24dB,
-20dB, -16dB, -12dB, -10dB, -8dB, -6dB0.0dB
(default) – +6.0dB (0.5dB increments), +7.0dB
+18.0dB (1.0dB increments)
MIC LEVEL (when BALANCE INPUT GAIN screen setting is
MIC-LOW or MIC-HIGH)
Options:
MUTE (minimum), -4.0dB0.0dB (default) –
+6.0dB (0.5dB increments), +7.0dB+31.0dB
(1.0dB increments), +31.5dB
DIGITAL LEVEL (INPUT SELECT screen set to DIGITAL CO-
AXIAL, DIGITAL XLR or IF-DA2 (DANTE))
Options: -6.0dB0.0dB (default value, 0.1dB incre-
ments) – +6.0dB
NOTE
When REC SET LINK is set to OFF on the REC 1 page, the lev-
els of the left and right channel inputs are adjusted separate-
ly.(see “Setting left/right channel inputs separately” on page
53)
3. Confirm the setting and return to the Menu Screen.
NOTE
You can use the level meters shown on the INPUT LEVEL
screen to check input levels as you adjust them. Set the level
so that they are as high as possible without exceeding the
level meter peak levels.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com