Loading...
15
3.5.2 Withdrawing a 5.25” Drive
1. Open the front bezel from either right or left side. However, taking off
the front bezel is recommended.
2. Take off the side panel.
3. Disconnect all cables.
4. Press the tabs of the slide rails on the front panel and pull the drive out
of the chassis
5. Free all four screws to release slide rails.
Fig. 3.5.3 Withdrawing 5.25” drive Fig. 3.5.4 Taking off slide
rails
3.6 The Modules
The installation or removing of a module is as easy as the way of
executing to a 5.25” drive. Please refer to the followings.
3.6.1 Installing a Module
1. Open the front bezel from either right or left side. As mention earlier,
remove the front bezel is recommended.
2. Take off the side panel.
3. Please measure the size of the module, and check how many drive bays
will be occupied.
4. Remove the bracket(s) of the drive bay(s) where you want to place the
module in. (Note: RAID module is assigned from bay 4 to bay 6).
5. Get slide rails from accessory pack. Attach rails on each side of module
and tighten all rails. In order to make sure the module is sited firmly in
chassis, please attach proper numbers of slide rails to each side of the
module.
6. Place the module all the way to the end into drive bay(s) where you
2
1
1
1
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com