Loading...
14
Fig. 3.4.3 Taking off 3.5” drive Fig. 3.4.4 Taking off screws
3.5 The 5.25” Drives
Installing or withdrawing a 5.25” drive can be done in couple
minutes. The following are the steps of manipulation.
3.5.1 Installing a 5.25” Drive
1. Open the front bezel from either right or left side. However, taking off
the front bezel is recommended.
2. Take off the side panel.
3. Remove the bracket of the bay where you want to place the 5.25” drive
in.
4. Get two slide rails from accessory pack. Attach one rail on each side of
5.25” drive, and tighten both rails with 3mm screws.
5. Place the 5.25” drive all the way to the end into the drive bay where the
bracket is taken off.
6. Connect all necessary cables.
7. Place the side panel back to case.
8. Close the front door, or place the bezel back.
Fig. 3.5.1 Installing slide rails Fig. 3.5.2 Installing 5.25” drive
1
2
2
2
1
1
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com