Loading...
13
3.4 The 3.5” Drive
Installing or extracting the 3.5” drive is an easy task. Please follow the
next steps for operations.
3.4.1 Installing the 3.5” Drive
1. Open the front bezel from left side. However, taking off the front bezel
is recommended.
2. Take off the side panel.
3. Loose the screws of the stand on the 3.5” drive bay, which is vertically
located on the left side of front panel. Take the stand off from back of
the front panel.
4. Place the 3.5” drive into the groove of the stand. Tighten the 3.5” drive
with four 3mm screws. Please refer to the following photo for the
proper holes to fasten screws.
5. Place the whole set back to the drive bay and tighten it with screws.
6. Connect all necessary cables.
7. Place the side panel back.
8. Close the front door, or place the bezel back.
Fig. 3.4.1 Tightening screws Fig. 3.4.2 Installing 3.5” drive
3.4.2 Extracting the 3.5” Drive
1. Open the front bezel from left side. However, taking off the front bezel
is recommended.
2. Take off the left side panel.
3. Disconnect all cables.
4. Free two screws on the front panel and take off the drive set
5. Free four screws on the side of drive stand and take the 3.5” drive out.
2
2
1
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com