Loading...
9
Ordercode: 40030
Phantom 120 Wash
Backside
Fig. 03
05) 3-pin DMX signal connector IN
06) 3-pin DMX signal connector OUT
07) Blue Pro Power connector IN
08) Fuse T3A/250V
09) Grey Pro Power connector OUT
10) Ground/earth connection
11) Power switch ON/OFF
Installation
Remove all packing materials from the Phantom 120 Wash RGBW. Check if all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com