Loading...
7
SCANNER INSTALLATION: POWERED BY HOST DEVICE (CONTINUED)
3. Plug the 4 position ground jumper
into the power supply connector.
4. Turn off the host system
5. If using a communication cable,
connect the cable to the correct port
on the host device and the MCA.
If the host device is an IBM
compatible with a male 9-pin serial
port, connect the MCA to the port.
There is an optional cable
(MLPN 51-51236) that is available for
IBM PC applications where the MCA
will not fit at the back of the
computer.
6. Plug the scanner’s coil cable into the
MCA.
7. Turn on the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the
requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
**To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power
source should meet applicable performance requirements for a limited power source.
Ground
Jumper
(direct)
Communication Cable (Optional)
MCA
Coil Cable
MS6720
Host
5
19
6
MCAFemale
9-pin D
Power Supply
Connector
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com