Loading...
15
D
EFAULT
S
ETTINGS
Many functions of the scanner can be "configured", that is enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
All factory default parameters have an asterisk ( * ) in the default column of the
charts on the following pages . If an asterisk is not in the default column then the
setting is off or disabled by default. Every interface does not support every
parameter. If the interface supports a parameter listed in the charts on the
following pages, a check mark () will appear.
P
ARAMETER
D
EFAULT
RS232 L
IGHT
P
EN
K
EYBOARD
W
EDGE
USB
Enter Program Mode After Any Scan *
Enter Program Mode Only on
First Scan
Short Range Activation
Long Range Activation *
Normal Scan *
Pulsing Scan
Custom Scan
Short Same Symbol Rescan
Long Same Symbol Rescan *
Alternate Beeper Tone 1
Alternate Beeper Tone 2 *
Alternate Beeper Tone 3
No Beeper Tone
Two Second Timeout
No Two Second Timeout *
Razzberry Tone on Timeout
No Tone on Timeout *
Three Beeps on Timeout
Beep Before Transmit *
Beep After Transmit
Baud Rate 9600
Parity Space
8 Data Bits
7 Data Bits *
RTS/CTS
Character RTS/CTS *
Message RTS/CTS
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com