Loading...
64
SCANNER OPERATION
POWER SAVE MODES
The MS2020 has five programmable power save modes. Refer to the
MetroSelect Programming Guide for additional information on Power Save
Modes.
1. Blink Power Save Mode:
Blinks the laser OFF & ON after a programmed period of non-use.
When the scanner recognizes a bar code it will exit the Blink mode.
2. Laser Off Power Save Mode:
Turns the laser OFF after a programmed period of non-use. The motor
continues to spin allowing for a faster “wake” up time.
Any movement detected by the IR will “wake” the scanner from the Laser Off
power save mode (see figure 47 on page 56).
3. Laser & Motor Off Power Save Mode:
Turns the laser and motor OFF after a programmed period of non-use.
Any movement detected by the IR will “wake” the scanner from the power
save mode (see figure 47 on page 56). This mode’s “wake” time is slightly
longer due to the motor’s need to restart.
4. Dual Action Power Save Mode #1:
“Blinks” the laser OFF & ON after a programmed period of non-use turns the
laser and motor OFF at thirty-minute intervals.
Example:
If the power save timeout
is set to 15 minutes.
Any movement detected by the IR will “wake” the scanner from the power
save mode (see figure 47 on page 56).
Laser starts
“Blinking”
Laser & Motor
turns OFF
Last
Scan
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com