Loading...
57
SCANNER OPERATION
INDICATOR DESCRIPTIONS
Audible
When the MS2020 is in operation, it can provide audible feedback. These
sounds indicate the status of the scanner. Eight settings are available for the
tone of the beep (normal, 6 alternate tones and no tone) plus three volume
settings. To change the tone or volume, refer to the Changing the Beeper Tone
& Volume section of this manual.
One Beep
When the scanner first receives power the white LED will flash, the
blue LED will turn on and the scanner will beep once (the white
LED will remain on for the duration of the beep). The scanner is
now ready to scan.
When the scanner successfully reads a bar code, the white LED
will flash and the scanner beeps once (if programmed to do so). If
the scanner does not beep once and the white light does not flash,
then the bar code has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes on page 60.
Three Beeps - during operation
When placing the scanner in program mode, the white LED will
flash while the scanner simultaneously beeps three times. The
white and blue LEDs will continue to flash until the unit exits
program mode. Upon exiting program mode, the scanner will beep
three times and the white LED will stop flashing.
When configured, 3 beeps can also indicate a communications
timeout during normal scanning mode.
When using one-code-programming, the scanner will beep three
times (the current selected tone), followed by a short pause, a high
tone and a low tone. This tells the user that the single configuration
bar code has successfully configured the scanner.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes on page 60.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com