Figure 39. Secondary Scanner Cable Installation Schematic
xxx* Specifies connection to the host. Contact a Metrologic representative for
The MS202x/host cable connection is interface dependent. Refer the
installation steps provided for the type of interface required for your
xx** Specifies international connection. See the Base Kit Components and
Optional Accessories section of this guide for a complete listing.
† See Aux power notes on page 49.
Caution: To maintain compliance with applicable standards, all circuits connected to
the scanner must meet the requirements for SELV (Safety Extra Low
Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and
norm EN/IEC 60950, the power source should meet applicable performance
requirements for a limited power source.