Loading...
48
INSTALLATION
INTEGRATED SCALE ON SINGLE CABLE SCANNER/SCALE SYSTEM
Changing Scale Defaults
The following bar codes change the defaults installed by the bar codes
mentioned above.
When it is desired to give the English Mode weight in 5
digits, as in xx.yyy pounds, scan the “5-digit Weight” bar
code AFTER any of the English scale defaults
mentioned previously.
5-Digit Weight
³141010
No Remote Display
³140902
When it is desired to remove the scale’s display form
scanner memory because none is installed, use the “No
Remote Display” bar code AFTER any of the main
defaults mentioned previously.
When it is desired to use the previously mentioned
protocols without the scale or the scale is in a Dual
Cable environment, scan the “No Scale” barcode
AFTER any of the main defaults mentioned previously.
This is only needed if scanning one of the single cable
protocols as no scale in the default condition otherwise.
*No Scale
³141407
Dual Cable Scanner/Scale Units
In a dual cable environment, the scanner and scale work independently. The
scanner can be programmed to a stand-alone protocol by using one of the main
single cable protocols mentioned previously and then remove the scale, or by
use of the following bar code, which inherently does not include a scale.
Scanner Only Protocol RS232 Mode.
This interface uses the Scanner -Only Command set for
scanners operating independently or without a scale
installed.
Scanner Only Protocol
³999953
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com