Loading...
46
INSTALLATION
INTEGRATED SCALE ON SINGLE CABLE SCANNER/SCALE SYSTEM
The following bar codes configure the scanner to the desired interface and scale
parameters. These single cable interfaces handle all status and commands over
a single communication cable for both the scanner and scale. Each one will
provide different protocols between the scanner and a host device.
These bar codes are only used to configure the scanner. The scale is configured
with a special download utility. It is pre-configured for use at the factory so the
scale’s parameters such as units of measure, remote display required, single or
dual cable operation are all programmed at time of order. If desired to change
the scale’s configuration, please contact a Metrologic representative.
Scanner/Scale Single Cable RS232 Mode-English
Defaults. This interface uses the Scanner/Scale Single
Cable Command set for scanners with scales. Scale
parameters will default to display required, 4-digit weigh
mode, English units (lbs.).
1 Cable English
³999956
1 Cable Metric
³999955
Scanner/Scale Single Cable RS232 Mode-Metric
Defaults. This interface uses the Scanner/Scale single
Cable Command set for scanners with scales. Scale
parameters will default to display required, 5-digit weigh
mode, Metric units (kg.).
Scanner/Scale Single Cable RS232 OPOS Mode -
English Defaults. This interface requires the Metrologic
OPOS driver be installed on the host. The data
transmissions then use special formatting to
communicate. Scale parameters will default to display
required, 5- digit weigh mode, English units (lbs.).
OPOS English
³999958
OPOS Metric
³999957
Scanner/Scale Single Cable RS232 OPOS Mode -
Metric Defaults. This interface requires the Metrologic
OPOS driver be installed on the host. The data
transmissions then use special formatting to
communicate. Scale parameters will default to display
required, 5-digit weigh mode, Metric units (kg.).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com