Loading...
7
INSTALLING THE SCANNER TO THE HOST SYSTEM
STAND ALONE KEYBOARD
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector into the jack on the
Voyager or VoyagerCG. You
will hear a ‘click’ when the
connection is made.
If the scanner is
receiving power from
the host system, skip to
step #5.
3. Connect the L-shaped plug of
the power supply into the power
jack on the PowerLink cable.
4. Make sure the AC input
requirements of the power
supply match the AC outlet.
Connect the power supply into
an AC outlet. The outlet should
be near the equipment and
easily accessible.
5. Connect the PowerLink cable to
the keyboard port on the host
system.
6. Turn on the host system.
Powering the MS9520-47/MS9540-47 directly from the computer can
sometimes cause interference with the operation of the scanner or the
computer. Not all computers supply the same current through the
keyboard port, explaining why a scanner would work on one computer and
not another. Contact a Metrologic Customer Service Representative if you
require an external power supply.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the
power source should meet applicable performance requirements for a limited power source.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com