Loading...
8
Ordercode: 42199
LED Light Bar 8
One Light Bar (Built-in programs,Macro colors)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) When the Light Bar is not connected by a DMX-cable, it functions as a stand-alone device.
03) If device is set to or , then the fixture will play one of its built-in programs or show
one of its macro colors. Please see pages 15-18 for more information about the built-in programs or
macro colors.
One Light Bar (Sound-control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) When the Light Bar is not connected by a DMX-cable, it functions as a stand-alone device.
03) Turn on the music. If device is set to (Audio) and you have pressed enter, then the fixture
will react to the beat of the music. Please see page 15 for more information about the Sound-
controlled mode.
Multiple Light Bars (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Use a 3-p XLR cable to connect the Light Bar and other devices.
The pins:
1. Earth
2. Signal (-)
3. Signal (+)
04) Link the units as shown in (Fig. 02), connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, and third units. You can use the
same functions on the master device as described on page 14-17 (Built-in Programs). This means you
can set your desired operation mode on the master device and all slave devices will react the same
as the master device.
Multiple Light Bars (Master/Slave control)
Fig. 02
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com