Loading...
8
Figure 7.
INSTALLING THE SCANNER TO THE HOST SYSTEM
USB: LOW SPEED HID/POS USB MS5145-38
FULL SPEED USB MS5145-40
1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector
of the USB cable into the jack on the
Eclipse. You will hear a ‘click’ when the
connection is made.
3. Connect the other end of the USB cable to
the host USB port.
4. Turn on the host system.
Plugging the scanner into a port on the
host system does not guarantee that
scanned information will be
communicated properly to the host
system. All Eclipse’s are shipped
already configured with a set of factory
defaults. Please refer to the MetroSelect
Configuration Guide or MetroSet2’s help files
for instructions on changing the scanner’s
configuration. It is important to check that
the scanner and host system are using the
same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the
power source should meet applicable performance requirements for a limited power source.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com