Loading...
Tally Dascom DT-210/230
21
3 Setting DIP Switches
You will see a metal plate on the bottom of the printer. Remove the metal plate with a screwdriver you will
find two DIP switches on the main control board as showm below.
There are two DIP switch banks on the main controller board (SW1 and SW2), eight DIP switches for each
bank. These DIP switches can be set on/off, using the tip of a tool, such as a small screwdriver.
The printer parameter such as printer density, baud rate, and auto-cutter enable/disable etc. can be set via
these two DIP switches as follows.
Note: New DIP switch settings are enabled after the printer is turned on!
DIP Switch 1
DIP Switch 2
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com