Loading...
Tally Dascom DT-210/230
6
1.6 Adjusting the near end sensor
Open the printer cover you will see a black lever inside as shown below.
The DT-230 has a paper near-end sensor that provides notice that the paper roll is nearly exhausted. When
the paper is running low, the paper LED is lit red.
If you find that there is not enough paper remaining on the roll when the near-end sensor is triggered, you
can change the near-end sensor setting.Rotate the near-end lever at front or rear position.
The paper near end lever is continuously adjustable from β€œ1”to”6”.
1.Minimum paper remains until paper end,paper roll diameter about 25.9mm.
2. Paper remains until paper end, paper roll diameter about 26.9mm.
3. Paper remains until paper end, paper roll diameter about 28.3mm.
4. Paper remains until paper end, paper roll diameter about 29.7mm.
5 .Paper remains until paper end, paper roll diameter about 31.8mm.
6.Maximun paper remains until paper end,paper roll diameter about 32.6mm.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com