User guide Settings
Setting the tear
If the tear position of the paper is not aligned with the tear edge of
the printer, you can adjust it. Inserted paper needs to be torn off if
necessary and retracted to park position.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key.
The tear edge is located at the front side of the paper output opening
(see Printer at a glance (page 2).
Press the < (2) or > (3) key to move the perforation to the desired
position. Confirm the input by pressing the Set (1) key. Confirm the
input again by pressing the Setup key. The printer is reset to the in-
The correction made – a maximum of approx. 1" (2.5 cm) in
each direction – will be retained after switching the printer off.
It can be set separately for each paper path.
Make sure that the set form length corresponds to the actual
length of the forms you are using.
Set < > Exit
D ĂŶƚĞŶŝŵŝĞŶƚŽW ĞƌŝĨĠƌŝĐŽƐ/ŶĨŽƌŵĂƚŝĐŽƐ ͬ ĂŶƚĞƌĂƐ͕ϭϱϮϴϴϲϬW ĂƌĂĐĂƵĞůůŽƐĚĞ:ĂƌĂŵĂ;D ĂĚƌŝĚͿdĞů͗ϬϬϯϰϵϭϳϰϴϭϲϬϰt Ğď ͗ŚƚƚƉƐ͗ͬͬŵƉŝ͘ĐŽŵ͘ĞƐͬ