Ordercode: 50396
Single DP-1
Control Panel
A) LED display
B) DMX LED indicator
C) MENU button
D) UP button
E) DOWN button
Fig. 03
Control Mode
The Single DP-1 is individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the DP will respond to the controller.
Please note, when you use the controller, the unit has 1 channel.
After having addressed all DP fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the DP will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the “LED “ on the control panel will not flash.
If not, the problem may be:
The XLR cable from the controller is not connected with the input of the Single DP-1.
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com