Loading...
6
Ordercode: 50396
Single DP-1
Installation
Remove all packing materials from the Single DP-1. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Connection Example
Fig. 02
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
The Single DP-1 is equipped with the power failure memory. This means that the device remembers the
last active settings and operation mode and is able to restore them in case of a power shortage. The
Single DP-1 can be used as a dimmer pack or a switch pack.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com