Loading...
Tally Dascom 1125
36
Adjust Physical Margins
Adjust Page Margins allows for adjustments of physical left, top margins and tear-off position. Warning: Once
these settings are changed, resetting the printer to factory defaults will not initialize these settings back to the
original settings; so it is not advisable to perform this adjustment unless it is absolutely necessary.
Adjust Top Margin Procedure:
1. Enter the Adjust Page Margins function by holding down theLoad/EjectandOnlinekeys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
LF/FF=OK Tear/Off= Back Load/Eject= Next Online= Exit
Current Setting: Adjust Fanfold Top Margin
PressLF/FFkey to confirm selection if the paper used is fanfold type. The printer will print as
follows:
Procedure
Install fanfold paper to tractors
LF/FF= AddLoad/Eject= ReduceOnline= Exit
Each step is 0.5 mm
Function of keys:
Tear Offkey: Decrease 0.5mm
Load/Ejectkey: Increase 0.5mm
4. Press LF/FF key, printer will print “Save settingsYes ”. Press Load/Eject key to choose Yes
or Nothen press LF/FFkey to confirm selection and exit Adjust Page Margins” mode by
pressingOnline. The print head moves to the left side and the printer beeps twice, then the print
head moves to the middle position.
Adjust Left Margin Procedure:
1. Enter the Adjust Page Margins function by holding down theLoad/EjectandOnlinekeys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
LF/FF=OK Tear/Off= Back Load/Eject= Next Online= Exit
Current Setting: Adjust Fanfold Top Margin
4. Press
Load/Ejectkey until the current setting is “Adjust Fanfold Left Margin”
. PressLF/FFkey to
confirm selection if the paper used is fanfold type. The printer will print as follows:
Adjust Fanfold Left Margin 0
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com