Tally Dascom 1145/1125+
Auto, Manual, View,
Auto: Form Feed command from the host causes
the printer to advance the paper to the tear-off
position. Printing resumes on the TOF on next page.
Manual: After the completion of a print job, press a
panel key to advance the paper to the tear-off
View: No incoming print data in 1~2 seconds after
printing completed causes the printer to advance
the paper by 2 lines. Printing resumes 2 lines below
the torn edge.
Auto@FF: a formfeed command is necessary to
auto feed the form to tear position.
No: The printer stops printing if out of paper.
Yes: The printer continues printing even out of
Disable: No compression on the print line exceeding
the printable width.
Auto: The print squeezes an over-width print line
(not exceeding 22" in contents) to the printable
Other Compression Ratio: For example, a ratio of
11: 8 commands the printer to take this line
**Remark: The compression is disabled after printer
reset or loading a new page.
Determines if the cut sheet is jammed or skew.
Invalid: Disables the detection of both.
Anti-jam: Detect paper jam only.
Anti-Skew: Detect paper skew only.
Valid: Enables the detection of both.
No: Buzzer does not sound if out of paper.
Yes: Buzzer sounds if out of paper.
This printer saves the tear-off position before
switched off. After switched on, the printer if any
change in the tear-off position and determines the
start printing position.
Invalid: Printing starts from previously switched off
Detect: If the tear-off position is unchanged or
smaller, printing starts from TOF position. If larger,
printing starts from previously switched off position.
Record: If the tear-off position is unchanged, printing
starts from TOF position. If changed, printing starts
from previously switched off position.