Loading...
5
GEMBIRD EUROPE B.V. http://www.gembird.eu
All brands and logos are registered trademarks of their respective owners
3DP-PEN-01
FREE FORM 3D PRINTING PEN FOR ABS/PLA FILAMENT
2. Press the filament loading button, it start to heat and the green
light will flash. After around 40 seconds, the green light stop flashing. It
means it is ready for loading filament.
3.Insert the 1.75mm filament into the "filament loading hole". Keep
pressing the "filament loading button", the material will be loaded. Hold till
plastic material comes out from the nozzle, it means the filament is ready.
(Double press the Loading button can load the filament automatically, press
this button again to exit automatic mode).
4. Temperature adjustment: open the black cover and
use the plastic screwdriver to turn the temperature switch (clockwise is
increase the temperature, anticlockwise is reduce the temperature, each
level is 15°C), temperature range is 130°C-240°C.
5. Speed adjustment: slip the speed controller to adjust the speed.
6 Unload filament: press the unload filament button, the filament will
move out automatically (double press the Unload button can unload the
filament automatically, press this button again to exit automatic mode).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com