Loading...
Appendix A Standard Default Parameters
Table A-1
Standard Default Parameters Table
Parameter Parameter
Number Default Page
Number
User Preferences
Set Default Parameter Set Defaults
4-4
Parameter Bar Code Scanning ECh Enable
4-5
Beep After Good Decode 38h Enable
4-5
Beeper Tone 91h Medium
4-6
Beeper Volume 8Ch High
4-7
Volume Adjustment Trigger Timeout F0h 93h 5.0 Sec
4-8
Beeper Duration F1h 74h Medium
4-9
Suppress Power-up Beeps F1h D1h Do not suppress
4-9
Low Power Mode 80h Disable
4-10
Time Delay to Low Power Mode 92h 1 Hour
4-11
Trigger Mode 8Ah Presentation
4-13
Trigger Aiming Pattern F0h 32h Enable
4-14
Presentation Aiming Pattern F1h 4Eh Disable
4-15
Momentary Trigger Mode Timeout EDh 5 sec
4-16
Motion Detect Range F2h 3Bh Full
4-17
Post Decode Illumination F2h 29h Always Off
4-18
Presentation Mode Field of View F1h 61h Full
4-18
1
User selection is required to configure this interface and this is the most common selection.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com