Loading...
ZebraLink WebView - Print Server
Configuring the Print Server
88
14197L-005 10/100 Internal Print Server User Guide 11/12/2009
Table 10 • Print Server Configuration Menu Options
TCP/IP Configuration
You can change the TCP/IP configuration of the
10/100 Internal PS.
IP Address: Use this feature to set the IP
address if using the Permanent addressing
method.
IP Protocol: Use this feature to select the
Dynamic Addressing method to use at
startup. Choices include: ALL, GLEANING
ONLY, RARP, BOOTP, DHCP, BOOTP and
DHCP, or PERMANENT.
Default Address Enabled: This setting
determines if the printer will use its default
address, if no address is provided through
DHCP or BOOTP. If no address is assigned
after two minutes, the print server defaults to
IP address 192.168.254.254.
Subnet Mask: Use this feature to set the
subnet mask. The subnet mask must follow
the format XXX.XXX.XXX.XXX, where
each XXX is a number between 0 and 255.
Default Gateway: Use this feature to set the
default gateway. This gateway will be used
whenever messages need to be sent to
another network. This gateway address must
follow the format XXX.XXX.XXX.XXX,
where each XXX is a number between 0 and
255.
WINS Server IP Address: Use this feature
to set or view the IP address of the WINS
Server.
Connection Timeout Checking: Use this
feature to enable or disable the Connection
Timeout feature. The timeout is used to close
network TCP/IP connections that are idle for
more than the number of seconds entered in
the Timeout Value.
Timeout Value (secs): Use this feature to set
the Connection Timeout Value. The Valid
range is 10 to 3600 seconds. The default is
300 seconds.
ARP Broadcast Interval (mins): Use this
feature to set interval for sending an ARP
Broadcast. The valid range is 1 to 30 minutes.
Address Resolution Protocol (ARP)
broadcast packets allow other network
devices to associate the print server's IP
Address with its hardware address.
Base Raw Port Number: Use this feature to
set the raw TCP port that the print server will
use for printing tasks. The default is port
9100.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com