Loading...
29
Getting Started
Defaulting the 10/100 Internal PS
11/12/2009 10/100 Internal Print Server User Guide 14197L-005
Defaulting the 10/100 Internal PS
This section provides you with instructions for defaulting the 10/100 Internal PS to factory
settings using the control panel, WebView, and ZebraNet View.
Defaulting the 10/100 PS on the ZM400 and ZM600 Printers
To default the 10/100 Internal PS to factory settings using the control panel on
the ZM400 or ZM600 printers, complete these steps:
1. From the control panel, press Setup/Exit two times.
2. Press Plus (+ button) five times.
The control panel will read DEFAULT NET.
3. Press Setup/Exit to save the change.
After the printer defaults all settings, the control panel will show PRI NTER READY.
Defaulting the 10/100 PS on the G-Series, ZP Series, and 2824 Plus
Printers
For the G-Series, ZP Series, and 2824 Plus printers, select one of the following methods to
default the print server for these printers:
Use the web page in WebView — see Defaulting the 10/100 Internal PS Using WebView
on page 31 for further details.
Use the ZebraNet View utility — see Defaulting the 10/100 Internal PS Using ZebraNet
View on page 32 for further details.
Issue the ZPL command shown immediately below or refer to the ZPL II Programming
Guide for further details.
^XA^JUN^XZ
Use ZebraNet Bridge to manage the print server — see the ZebraNet™ Bridge Enterprise
User Guide for further details.
Note • To download a copy of either of the guides mentioned above, visit the Zebra web site
at: www.zebra.com/manuals.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com