Loading...
23
Getting Started
Before You Begin
11/12/2009 10/100 Internal Print Server User Guide 14197L-005
Print a Configuration Label
1. Which printer do you have?
If you have a… Then…
ZM400 and ZM600 a. Turn on (I) the printer and let it complete its power-up
cycle.
b. When the POST cycle is complete, press Setup/Exit to
enter the Setup Mode.
c. Scroll through the parameters by pressing Plus (+) until
you reach Li s t Net wor k .
d. Press Select.
e. Press Plus (+) to print a network configuration label
(Figure 2).
f. Press Setup/Exit twice to exit the Setup Mode.
g. Continue to step 2.
G-Series, ZP Series,
and 2824 Plus
a. Turn on (I) the printer and let it complete its power-up
cycle.
b. Press and hold Feed until you see one flash of the LED.
c. After the LED flashes, release the button. A network and
printer configuration label (See Figure 3) prints.
d. Continue to step 2.
HC100 Note • The HC100 does not have a network
configuration label. However, the IP Address, MAC
Address, and other useful information appear on the
printer configuration wristband.
a. Turn on (I) the printer and let it complete its power-up
cycle.
b. Press and hold Pause/Feed until the green lights turn off
on the printer status indicator and the orange lights blink
once.
c. Release Pause/Feed to print a printer configuration
wristband (Figure 4).
d. Continue to step 2.
Xi4 a. Turn on (I) the printer and let it complete its power-up
cycle.
b. When the POST cycle is complete, press Setup/Exit to
enter the Setup Mode.
c. Scroll through the parameters by pressing Next/Save
() until you reach Li st Net wor k .
d. Press Plus (+) to print a network configuration label
(Figure 5).
e. Press Setup/Exit to exit the Setup Mode.
f. Press Next/Save to permanently save your changes.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com