Loading...
111
Hardware Troubleshooting
Troubleshooting the 10/100 PS
11/12/2009 10/100 Internal Print Server User Guide 14197L-005
Telnet
Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be
used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to
cause a label to print.
To open a telnet session on your PC, complete these steps:
1. Open a DOS window.
To open a DOS window, click on Start > Run.
2. In the Open text box, type: cmd
3. From the DOS prompt, type:
telnet xxx.xxx.xxx.xxx 9100
where xxx.xxx.xxx.xxx is the IP address of the print server.
This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.
4. Enter ~WC.
This ZPL command will print a configuration label on your printer.
5. Click the X in the upper right-hand corner of the window to exit.
If the configuration label prints, the issue is not a communication problem between the printer,
the print server, or the PC.
Unable to Configure Device
To assign an IP address to a ZebraNet 10/100 Internal PS using ZebraNet View, you must be
on the same subnet. If ZebraNet View has Multicast enabled, you may be able to view the
ZebraNet 10/100 Internal PS on another subnet, but you will not be able to configure the
device.
Note • You do not need to open a telnet session if you pinged the printer using the previous
procedure. The purpose of these two procedures is to identify whether your PC can
communicate with your printer.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com