Loading...
57
Operations
Control Panel LCD Display
10/27/05 S4M Maintenance Manual 13291L-001 Rev. A
PRI NT SPEED Adjust Print Speed
Adjusts the speed for printing a label (given in whole numbers of inches
per second). Slower print speeds typically yield better print quality. Print
speed changes take effect upon exiting Setup mode.
Range: 2 to 6 IPS
Default Value (ZPL, APL-I): 2 IPS
Default Value (EPL, APL-D): 6 IPS
To modify this parameter:
To increase the value, press the up arrow.
To decrease the value, press the down arrow.
PRI NT WI DTH Set Print Width
Print width determines the printable area across the width of the label.
Important • Setting the width too narrow can result in portions of
the label not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off the label and
on the platen roller. This setting can affect the horizontal position
of the label format if the image was inverted using the ^POI
ZPL II command.
Range: 2 to 832 for 8 dots/mm, 2 to 1248 for 12 dots/mm
Default Value: 832 for 8 dots/mm, 1248 for 12 dots/mm
To modify this parameter:
To increase the value, press the up arrow.
To decrease the value, press the down arrow.
COMPAT. MODE
(APL-D mode only)
Set APL-D Compatibility Mode
Sets compatibility with DPL printers.
Selections: ON, OFF
Default Value: OFF
To modify this parameter:
Press the up or down arrow to scroll through the selections.
CONTROL CODES
(APL-D mode only)
Set APL-D Control Codes
Selections: STANDARD, MAINFRAME
Default Value: STANDARD
To modify this parameter:
Press the up or down arrow to scroll through the selections.
Table 11 • Printer Parameters, Password Levels 1 and 2 (Page 4 of 5)
Parameter Explanation
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com