Loading...
293
Preventive and Corrective Maintenance
Booster Board
10/27/05 S4M Maintenance Manual 13291L-001 Rev. A
Booster Board
This procedure is for installing the booster board into the S4M printer. Read these instructions
thoroughly before performing this procedure.
Prepare for Installation
Reference Materials
The following manuals and CDs may be helpful references while performing this procedure.
S4M User Guide
S4M User Guide CD
S4M Maintenance Manual CD
Tools Required
Remove the Booster Board
1.
Connect yourself to an antistatic device.
2. See RRP No. 1 on page 122 and remove the electronics cover.
3. See Figure 160. Remove the booster board cable (J7) from the main logic board.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following procedure.
Caution • A qualified service technician must perform this installation.
Tools • You need these tools to complete this procedure:
Phillips Screwdriver Set
Metric Nutdriver Set
Anti-Static Wriststrap and Mat
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com