Loading...
Preventive and Corrective Maintenance
Control Panel
274
13291L-001 Rev. A S4M Maintenance Manual 10/27/05
Control Panel
This procedure is for installing the control panel in the S4M printer. Read these instructions
thoroughly before performing this procedure.
Reference Materials
The following manuals and CDs may be helpful references while performing this procedure.
S4M User Guide
S4M User Guide CD
S4M Maintenance Manual CD
Tools Required
Remove the Old Control Panel
1.
Connect yourself to an antistatic device.
2. See RRP No. 1 on page 122 and remove the electronics cover.
3. Disconnect the control panel ribbon cable from J2 on the main logic board (MLB).
4. If installed, remove the take-label sensor cable from J19 on the MLB and then remove it
from the conduit.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following procedure.
Tools • You need these tools to complete this procedure:
Phillips Screwdriver Set
Metric Nutdriver Set
Anti-Static Wriststrap and Mat
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com