Dancer Maintenance Kit
Dancer Assembly
10/27/05 S4M Maintenance Manual 13291L-001 Rev. A
Remove the Old Dancer Assembly
1. Turn Off (O) the printer and disconnect the power cord and all data cables.
2. See Figure 130. Open the media door and remove the media and ribbon.
Figure 130 • Open the Media Door
3. See Figure 131. Relieve the spring tension from the dancer assembly by using a long
needle nose pliers to move the torsion spring leg off the printer post.
Remove the E-ring, then slide off the bearings, the dancer, and the torsion spring.
1Media door
2Dancer assembly
Caution • Wear protective eyewear when installing or removing E-rings, C-clips, snap
rings, springs, and mounting buttons. These are under tension and could fly off.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com