Preventive and Corrective Maintenance
10/27/05 S4M Maintenance Manual 13291L-001 Rev. A
2. See Figure 127. Notice the pems and the mounting slots.
Figure 127 • Rear View of Peel Assembly
3. See Figure 126 on page 244. Install the peel assembly with the pems to the rear and the
opening in the mounting slot to the top.
a. Insert the mounting slot opening over the two screws and lift up on the assembly.
b. Now push the assembly back against the vertical surface of the platen housing then
down, so that the pems are resting on the horizontal surface of the platen housing.
4. Maintain a slight pressure downward on the peel assembly to keep the pems on the
horizontal surface, and tighten the mounting screws.
1Mounting slots (2)