Loading...
227
Preventive and Corrective Maintenance
Stepper Motor and Gear/Pulley
10/27/05 S4M Maintenance Manual 13291L-001 Rev. A
Stepper Motor and Gear/Pulley
This procedure is for installing the stepper motor and gear/pulley in the S4M printer. Read
these instructions thoroughly before performing this procedure.
Reference Materials
The following manuals and CDs may be helpful references while performing this procedure.
S4M User Guide
S4M User Guide CD
S4M Maintenance Manual CD
Tools Required
Remove the Old Stepper Motor
1.
Connect yourself to an antistatic device.
2. See RRP No. 1 on page 122 and remove the electronics cover.
3. See Figure 114. Locate the stepper motor and drive belt.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following procedure.
Tools • You need these tools to complete this procedure:
Phillips Screwdriver Set
Metric Hex Key (Allen Wrench) Set
Anti-Static Wriststrap and Mat
Metric Nutdriver Set
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com