Preventive and Corrective Maintenance
Ribbon Take-Up Spindle Clutch
13291L-001 Rev. A S4M Maintenance Manual 10/27/05
Ribbon Take-Up Spindle Clutch
This procedure is for installing the Ribbon Take-up Spindle Clutch into the S4M printer. Read
these instructions thoroughly before performing this procedure.
Prepare for Installation
Reference Materials
The following manuals and CDs may be helpful references while performing this procedure.
S4M User Guide
S4M User Guide CD
S4M Maintenance Manual CD
Tools Required
Remove the Main Logic Board
Connect yourself to an antistatic device.
2. See RRP No. 1 on page 122 and remove the electronics cover.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following procedure.
Tools • You need these tools to complete this procedure:
Phillips Screwdriver Set
Metric Hex Key (Allen Wrench) Set
Metric Nutdriver Set
Anti-Static Wriststrap and Mat
Metric and inch Feeler Gauges, must
include: 0.020 (.508mm)
Note • Retain all parts removed during disassembly, unless otherwise directed.
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com