Loading...
Preventive and Corrective Maintenance
Take-Label Sensor
192
13291L-001 Rev. A S4M Maintenance Manual 10/27/05
Figure 88 • Remove and Install the Control Panel
5. Remove the mounting screw and washers securing the control panel.
6. Tip the top of the control panel away from the main frame enough to release the two tabs
inserted into the base and then pull it out of the base.
7. Carefully guide the control panel cable and the take-label sensor cable, if installed,
through their access holes.
8. Are you replacing a defective take-label sensor?
1Main frame 8Star washer
2Main logic board (MLB) 9Control panel
3J19, Take-label sensor 10 Tab
4Control panel cable 11 Cable access hole
5J2, control panel 12 Access hole
6Mounting screw 13 Conduit
7Split washer
If... Then...
Yes Continue with Remove the Take-Label Sensor Board on page 193.
No Go to Install the Take-Label Sensor Board on page 194.
124
37
13 11
5
12 10
689
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com