Preventive and Corrective Maintenance
13291L-001 Rev. A S4M Maintenance Manual 10/27/05
Figure 64 • Remove and Install the Cables
Install the New Printhead Cables
1. See Figure 64. Slide each of the cables through the hinge and into the print mechanism.
See Figure 63. Connect the printhead cables to the printhead fork assembly.
3. Reinstall the printhead fork assembly into the print mechanism.
Ensure that the printhead cables are up and away from the printhead to avoid damage to
the new cables and to allow the printhead to seat properly.
4. Use the thumbscrew removed previously to secure the printhead fork assembly.
1Printhead data cable
2Printhead power cable
4Printhead data connector
5Printhead power connector
Caution • An improperly connected printhead data or power cable may cause the
printhead to generate excessive heat and/or a false HEAD COLD message to display
while the printhead is hot enough to cause severe burns. Allow the printhead to cool.