Loading...
DU9800Z DLP Projector - User Manual
53
UM98001117EN00
Background
User can use this function to specify the image displayed on the blank screen when there is no input signal. The
selectable items are Logo, Black and Blue, the default setting is Logo.
Startup Logo
Press ENTER button, and use the or button to turn on / off the Startup Logo.
Infrared Remote
Remote Sensor: The default is On. However, there are three conditions that will be suggested to turn off “Remote
Sensor”; the possible condition is that if the user uses wired control, he can set this function to Off, or that if the
projector IR location is exposed to the bright sunlight or fluorescence, or that projector control is not controlled by
remote. If the user would like to reset to On, user can only set by OSD panel or RS-232.
ID Control Enable: This option allows you to enable the projector ID control function. You can turn on this function and
give an ID number for the projector, then set the same ID number for the remote control to match the projector ID. After
ID code is set, you can control the specified projector by the remote control.
Control ID Number: Select the option then press the or button to set the ID number of the projector, this option is
selectable when Projector ID Control is enabled.
Trigger 1, 2
The projector provides a set of trigger output ports for connection to a screen. The user can connect the triggers between
the screen and projector by a cable. Once the projector is powered on, the screen would be automatically turned on as
well. There is a 2-3 second delay to activate this function. The selectable aspect ratios are as follows:
Off: Turn off screen trigger.
5:4: Outputs 12V of power on Trigger when Aspect Ratio is set to 5:4.
4:3: Outputs 12V of power on Trigger when Aspect Ratio is set to 4:3.
16:10: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:10.
16:9: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:9.
1.88: Outputs 12V of power on Trigger when Aspect Ratio is set to 1.88.
2.35: Outputs 12V of power on Trigger when Aspect Ratio is set to 2.35.
Letterbox: Outputs 12V of power on Trigger when Aspect Ratio is set to Letterbox.
Native: Outputs 12V of power on Trigger when Aspect Ratio is set to Native.
Unscaled: Outputs 12V of power on Trigger when Aspect Ratio is set to Unscaled.
Auto: Outputs 12V of power on Trigger automatically.
OSD Settings
Menu Position: Adjust menu position through this function. The available position options are at Top-Left, Top-Right,
Bottom-Left, Bottom-Right and center of the screen.
Menu Transparency: Changes the transparency of OSD Menu. The background color of the OSD can be adjusted
from a darker solid color to a lighter transparent color.
Time Out: Set up the timer to exit OSD menu. The available options are Always On, 10 Seconds, 30 Seconds and 60
Seconds.
Message Box
This function allows you to disable the pop-up message on the bottom-right of the screen.
Image Latency
This function allows you to set image latency. Note that normally the image latency should be set to Normal for best
picture quality.
Normal: Set image latency to 2 frames.
Fast: Set image latency to less than 1.5 frames.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com