DU9800Z DLP Projector - User Manual
Erase the identification number of the remote control
The set ID number is overwritten if new ID number is set, you can press ID SET and CLEAR button to erase ID number of
the remote control.
Press ID SET and CLEAR buttons simultaneously The backlight of the buttons is flashing one time
Checking the identification number of the projector and remote control
The identification number of the projector and remote control can be checked by entering the SERVICE menu as per the
below image. “X” represents that the function is not enabled; the number 26 is the current identification number of the
Project ID Control function is available when the option is turned on and remote control wire is not
plugged into the wire remote jack port.
If ID Control Enable is set to Off, the projector can receive any control signal from the remote control.
Even if the ID number is set into the remote control.
Serial Number C712XXXXX01322
Software Version 1 ME11s-SE04-FE19
Software Version 2 LE02-18-RE02-3092
Control / Remote ID X / 26
Active Source HDMI 2
Singnal Format 1290x1200@50Hz
H/V Refresh Rate 61.816 KHz /49.93 Hz
Pixel Clock 158.242 MHz
Light Time 00048 HRs
Thermal Status ↩／►
Factory Restet ↩／►
Scroll ▲▼Item Adjust ◄►EXIT = Back
INPUT PICTURE ALIGNMENT CONTROL