DU9800Z DLP Projector - User Manual
Wired Remote Jack
Connect to WIRED REMOTE terminal
on the projector
Select 3G-SD as the input source.
Select DisplayPort as input source.
Select HDBaseT the input source.
Erase the set ID number of the remote control; refer to the section “Using
Control ID for Multi-projector Application”.
Freeze the projected image or resume the projection.
Set up ID number for remote control; refer to the section “Using Control ID
for Multi-projector Application”.
Remote Control Operating Range
The remote control uses the infrared transmission to control the projector. It is not necessary to point the remote directly at
the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote
will function well within a radius of about 10 meters (25 feet) and 15 degrees above or below the projector level. If the
projector does not respond to the remote control, move a little closer.