Loading...
DU9800Z DLP Projector - User Manual
10
UM98001117EN00
IO Panel
TRIGGER (12V +/-1.5V)
When connected to the screen through a 3.5mm cable,
the screen deploys automatically on startup of the
projector. The screen reacts when the projector is
powered off.
RS-232
The 9-pin D-sub interface is used to connect to the PC
control system and projector maintenance.
Component (V, H, B/Pb, G/Y, R/Pr)
Connect RGBHV or Component signal from computer or
component video enabled device
VGA
Provide the standard 15-pin VGA connection and can
connect to RGB, HD Component or personal computer.
MONITOR OUT
Connect to a monitor to display the projected content.
WIRED REMOTE
Connect the supplied remote controller to the projector
HDBaseT/LAN
Connect an Ethernet cable (Cat5/Cat6, not supplied)
from a computer, network device, or HDBaseT
transmitter.
HDMI 1
Connect the HDMI cable from a computer or video
device
DVI-D
Connect to DVI-D cable from a DVI-D output of the
device.
DisplayPort
Connect the DisplayPort cable from a computer or video
device.
SDI IN/OUT
Connect to SDI source.
HDMI 2
Connect the HDMI cable from a computer or video
device
3D SYNC IN / Out
Connect to the 3D IR synchronization signal transmitter.
Note for Trigger
When the projector is turned on, a control output signal (DC 12V) is delivered from this terminal.
Do not use this jack for anything other than intended use.
Note for Wired Remote
Please make sure whether the port for insertion is correct before the terminal of the wired remote
control is inserted. The remote control may be damaged if inserted to the wrong port such as trigger. Do
not use this jack for anything other than intended use.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com