Loading...
www.aleratec.com
10
Using the 1:5 HDD Cruiser
Loading the Hard Drives
1. Open the drive tray doors by lifting the tab on the left side of each drive bay
you wish to use.
2. Take the Hard Disc Drive (HDD) and align the drive’s SATA plug to the lower
right hand side of the drive bay.
3. Slide the HDD into the drive bay until it stops. The drive will still be about 1
inch outside of the bay. When the door is closed it will push and plug the HDD
into the duplicator.
4. Swing the drive bay door closed and press the left side of the door until the tab
latches. When it latches, a click can be felt and heard.
Note: If you are duplicating, the source hard disk drive goes in the top
bay.
Source Drive
Target Drives
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com